stretch wrapper

orbital stretch wrapper
1) The orbital wrapping machine cycle is dedicated to its timer control- this means if we push the STOP button, the C-Ring does not go back to its home position or starting position and we have to wait
Until the timer runs out, to be able to start again. Unfortunately even though “ WE ALREADY PUSH THE STOP BUTTON” “WE STILL NEED TO PUSH THE RESET BUTTON A LOT OF TIMES
To be able to start with another cycle again.
 
2) Your foot switch doesn’t have any usable function at all – we are expecting that the foot switch will do atleast the following task;
 
A- Timer control – if we push the foot switch or even the start button, “ THE WRAPPING machine SHOULD STARTS WITH THE TIMER COUNTDOWN
And if we push the stop button during the countdown even the timer is not yet done “IT MUST DISABLE THE RESET TIMER AND THE C-RING SHOULD GO BACK TO ITS HOME POSITION
OR STARTING POSITION TO GET READY ON A NEW CYCLE
 
B- Foot switch Manual Control – “THE WRAPPING CYCLE SHOULD START UPON PRESSING THE FOOT SWITCH AND WILL GRADUALLY STOP AND GOES BACK TO HOME POSITION ONCE RELEASED
To start a new cycle.

Leave a Reply

Your email address will not be published. Required fields are marked *